TI25011 Electrical Drives Syllabus:

TI25011 Electrical Drives Syllabus – Anna University UG Syllabus Regulation 2025

COURSEOBJECTIVES:
At the end of the course, students should have the ability to:
Understand the steady-state operation and transient dynamics of motor–load systems.
•Study and analyze the operation of converter- and chopper-fed DC drives, both qualitatively and quantitatively.
•Study and understand the operation and performance of AC induction motor drives.
•Study and understand the operation and performance of AC synchronous motor drives.
•Analyze and design current and speed controllers for closed-loop solid-state DC motor drives.

UNIT I – DRIVE CHARACTERISTICS
Electric drive – Equations governing motor load dynamics – Steady state stability – Multi quadrant dynamics: Acceleration, deceleration, starting and stopping – Typical load torque characteristics – Selection of motor.

UNIT II – CONVERTER/CHOPPER FED DC MOTOR DRIVE
Steady state analysis of single and three phase converter fed separately excited DC motor drive – Continuous and discontinuous conduction – Time ratio and current limit control – Four quadrant operation of converter and chopper fed drive.

UNIT III – INDUCTION MOTOR DRIVES
Stator voltage control – Energy efficient drive – V/f control – Constant air gap flux – Field weakening mode – Voltage source inverter and current source inverter fed drives – Closed loop control.

UNIT IV – SYNCHRONOUS MOTOR DRIVES
V/f control and self control of synchronous motor – Margin angle control and power factor control – Permanent magnet synchronous motor drive.

UNIT V – DESIGN OF CONTROLLERS FOR DRIVES
Transfer function for DC motor, load and converter – Closed loop control with current and speed feedback – Armature voltage control and field weakening mode – Design of controllers: Current controller and speed controller – Converter selection and characteristics.

30 PERIODS

LAB COMPONENT: 30PERIODS
1. Simulation of converter- and chopper-fed DC drives.
2. Simulation of closed-loop operation of stator voltage control of induction motor drives.
3. Simulation of closed-loop operation of V/f control of induction motor drives.
4. Simulation of synchronous motor drives.

TOTAL: 30+30=60PERIODS

TEXTBOOKS:
1. GopalK.Dubey,FundamentalsofElectricalDrives,NarosaPublishingHouse,2nd Edition January 2010.
2. BimalK.Bose.ModernPowerElectronicsandACDrives,PearsonEducation,2002 1st Edition.

REFERENCES:
1. S.K.Pillai,A First course on Electrical Drives,Wiley EasternL imited,3rdEdition2012.
2. MurphyJ.M.D and Turnbull, Thyrist or Control of AC Motor, Pergamon Press,Oxford1988,1stEdition.
3. GopalK.Dubey,PowersemiconductorcontrolledDrives,PrenticeHallInc.,NewJ ersey,1989, 1st Edition.
4. R.Krishnan, Electric Motor & Drives: Modeling, Analysis and Control, Prentice hall of India,2001, 1st Edition.