TI25012 SMPS and UPS Syllabus:
TI25012 SMPS and UPS Syllabus – Anna University UG Syllabus Regulation 2025
COURSEOBJECTIVES:
• To learn the working of isolated and non-isolated DC–DC converters.
• To design isolated and non-isolated DC–DC converters.
• To derive the equations related to converter dynamics.
• To design and simulate P, PI, and PID controllers for buck, boost, and buck–boost converters.
• To identify and study different configurations of UPS systems.
UNIT I ANALYSIS OF NON-ISOLATED DC–DC CONVERTERS
Basic topologies: Buck, Boost, and Buck–Boost converters – Principles of operation – Continuous conduction mode – Concepts of volt–second balance and charge balance – Analysis and design based on steady-state relationships – Introduction to discontinuous conduction mode.
UNIT II ANALYSIS OF ISOLATED DC–DC CONVERTERS
Introduction – Classification – Forward, flyback, push–pull, half-bridge, and full-bridge topologies – Cuk converter as a cascade combination of boost followed by buck – Isolated version of the Cuk converter – Design of SMPS – Introduction to the design of magnetic components for SMPS using relevant software – Simulation of bidirectional DC–DC converters (both non-isolated and isolated), considering EV as an example application.
UNIT III CONVERTER DYNAMICS
AC equivalent circuit analysis – State-space averaging – Circuit averaging – Transfer function models for buck, boost, and buck–boost converters – Simulation of basic topologies using derived state-space models – Comparison with circuit model–based simulations already carried out.
UNIT IV CONTROLLER DESIGN
Review of P, PI, and PID control concepts – Gain margin and phase margin – Bode plot–based analysis – Design of controllers for buck, boost, and buck–boost converters.
UNIT V POWER CONDITIONERS AND UPS
Introduction – Power line disturbances – Power conditioners – UPS: Offline and online – Need for filters – Filters for PWM VSI – Front-end battery charger – Boost charger.
30 PERIODS
LAB COMPONENT: 30 PERIODS
1. Simulation of basic topologies.
2. Simulation of bidirectional DC–DC converters (both non-isolated and isolated), considering EVs as an example application.
3. Simulation of basic topologies using derived state-space models and comparison with circuit model–based simulations already carried out.
4. Simulation study of controller design for basic topologies.
5. Simulation of battery chargers for EV applications.
TOTAL:30+30=60PERIODS
TEXTBOOKS:
1. Robert W. Erickson & Dragon Maksimovic, ” Fundamentals of Power Electronics”, Third Edition, 2020
2. Ned Mohan,” Power Electronics: A First Course”, Johnwiley, 2013.
3. Marian K. Kazimierczuk and Agasthya Ayachit,”Laboratory Manual for PulseWidth Modulated DC– DC Power Converters”, Wiley 2016.
4. Power Electronics handbook, Industrial Electronics series, S.K.Varenina, CRC press, 2002.
5. Power Electronic Converters, Teuvo Suntio, Tuomas Messo, Joonas Puukko, First Edition 2017.
