MV3511 Electrical Engineering, Electronics and Micro Processor Laboratory Syllabus:
MV3511 Electrical Engineering, Electronics and Micro Processor Laboratory Syllabus – Anna University Regulation 2021
COURSE OBJECTIVES:
• To impart Practical knowledge in
• Operation and maintenance of Electrical Machines
• Operation and maintenance of electronic equipment’s
• Operation and maintenance of Microprocessor
ELECTRICAL ENGG. LABORATORY
LIST OF EXPERIMENTS
1. Load Test on D.C. Shunt Motor
2. Load Test on D.C.Series Motor
3. O.C.C. & load characteristic of self/separately excited D.C. Generator.
4. Parallel operation of D.C.Shunt Generator
5. Speed control of D.C.Shunt Motor.
6. Load O.C. & S.C. test on single-phase transformer.
7. Parallel operation of single-phase transformers.
8. To connect similar single-phase transformers in the following ways.
9. Y-Y, A-A, A-Y and Y-A.
10. Load Test on Squirrel cage induction motor
11. Load Test on Slip ring induction motor
12. Pole changing motor for various speeds.
13. Synchronization of 3-phase alternator.
14. Trouble shooting in Electric Motors and Transformers.
15. Exercises in Power Wiring and earthing.
ELECTRONICS / MICROPROCESSOR LABORATORY
1. To study the volt-ampere characteristics of a high current semiconductor diode.
2. To study the volt-ampere characteristics of a diode and Zener diode.
3. To study the half wave and full wave rectification circuit without and with filter circuit.
4. To study the volt-ampere characteristics of a Transistor.
5. To study the volt-ampere characteristics of Field Effect Transistor.
6. To study the characteristics of Silicon Control Rectifier.
7. To study the Transistor Feed Back Amplifier.
8. To study the Integrated Circuit operational amplifier.
9. To study the logic training board.
10. To study the speed control of D.C. motor using Thyristor.
11. Arithmetic operations using 8085
12. Logical operations using 8085
13. Array operations using 8085
14. Speed & Direction Control of Stepper motor using 8085.
TOTAL: 60 PERIODS
COURSE OUTCOMES:
Upon Completion of the course, the students will be able to:
CO1: Conducting all types of tests on the Shunt and Series Motors,
CO2: Load tests on the Transformers, parallel operation of single phase Transformers Synchronizing three phase Alternators
CO3: Understanding the volt-ampere characteristics of Semiconductors, Diodes, Transistors, Field Effect transistor, Amplifier, Thyristor and 8085 Microprocessor.