PE25303 Fluid Mechanics and Solid Operations Syllabus:

PE25303 Fluid Mechanics and Solid Operations Syllabus – Anna University UG Syllabus Regulation 2025

Course Objectives: To impart to the student knowledge on fluid properties, fluid static and dynamic characteristics flow metering and transport, particle mechanics, techniques of solid – fluid separation.

Properties of Fluid: Newtonian fluids Classification of fluid motion Fluid statics – equilibrium of fluid element – pressure variation in a static fluid – Differential analysis of fluid motion – continuity, Euler’s and Bernoulli equation.
Activities: Numerical problems on fluid statics and Bernoulli equation; derivations and applications in engineering systems

Flow Through Pipes & Boundary Layer Concepts: Reynolds number regimes, Flow through pipes – pressure drop under laminar and turbulent flow conditions; boundary layer concepts; different types of flowmeters; Valves, pumps, compressors – characteristics and sizing; Agitation and Mixing.
Practicals: Centrifugal pump characteristics, Venturimeter, rotameters
Activities: Problem-solving on pressure drop and Reynolds number; analysis of pump and flow meter performance. Numerical problems on size reduction laws; case studies on industrial size reduction equipment

Size Analysis: General characteristics of solids, techniques of size analysis; Laws of size reduction, equipment for size reduction.
Practicals: Sieve analysis, Reduction ratio in Jaw Crusher / Pulverizer / Hammer Mill, Reduction ratio in Ball mill, Reduction ratio of Roll Crusher
Activities: Virtual demonstration of industrial screening and particle size analysis

Flow Through Fluidized Beds: Flow over a sphere – friction and pressure drag – flow through fixed and fluidized beds. Filtration – batch and continuous, filtration equipment – selection, operation.
Practicals: Pressure drop studies in packed column, Hydrodynamics of fluidized bed
Activities: Calculations on fluidization and pressure drop; analysis of filtration systems. Case studies on industrial separation techniques; numerical problems on sedimentation and
centrifugation

Classifiers: Screening, gravity separation – sedimentation, thickening, elutriation, classifiers – Centrifugal separation – continuous centrifuges, cyclones and hydro cyclones, electrostatic and magnetic separators.
Practicals: Separation characteristics of Cyclone separator, Characteristics of batch Sedimentations
Activities: Virtual demonstration of industrial air pollution control systems and the separation of particulate matter from gas streams.

Weightage: Continuous Assessment: 50%, End Semester Examinations: 50%.

Assessment Methodology: Assignments (20%), Experimental data analysis and design calculations (20%), Quiz/MCQs (20%), Internal Examinations (40%).

References
1. Noel de Nevers, “Fluid Mechanics for Chemical Engineers “, Third Edition, McGraw-Hill, (2005).
2. Badger W.L. and Banchero J.T., “Introduction to Chemical Engineering”, Fifth Edition, Tata McGraw Hill, 2001.
3. McCabe W.L, Smith, J C and Harriot. P “Unit operations in Chemical Engineering McGraw Hill, V Edition, 2001
4. Coulson, J.M. and Richardson, J.F., “Chemical Engineering” Vol. I, 4th Edn., Asian Book, Pvt. Ltd., India, 1998.