TI25008 Special Electrical Machines Syllabus:

TI25008 Special Electrical Machines Syllabus – Anna University UG Syllabus Regulation 2025

COURSEOBJECTIVES:
• To understand the working of special machines such as stepper motors, switched reluctance motors, BLDC motors, and PMSMs.
• To derive torque equations and study the characteristics of special machines.
• To design controllers for special machines.
• To study the working principle of synchronous reluctance motors.
• To simulate the closed-loop operation of BLDC motors.

UNIT I – STEPPER MOTORS
Constructional features – Principle of operation – Types – Torque predictions – Linear and non-linear analysis – Characteristics – Drive circuits – Closed loop control – Applications.

UNIT II – SWITCHED RELUCTANCE MOTORS
Constructional features – Principle of operation – Torque prediction – Characteristics – Power controllers – Control of SRM drive – Speed control – Current control – Design procedures – Sensorless operation of SRM – Current sensing – Rotor position measurement and estimation methods – Sensorless rotor position estimation – Inductance based estimation – Applications.

UNIT III – PERMANENT MAGNET BRUSHLESS DC MOTORS
Fundamentals of permanent magnets – Types – Principle of operation – Magnetic circuit analysis – EMF and torque equations – Characteristics – Controller design – Transfer function of machine, load and inverter – Current and speed controller.

UNIT IV – PERMANENT MAGNET SYNCHRONOUS MOTORS
Permanent magnet AC machines – Machine configurations – PMSM principle of operation – EMF and torque equations – Phasor diagram – Torque speed characteristics – Evaluation of control characteristics – Design of current and speed controllers – Constructional features, operating principle and characteristics of synchronous reluctance motor.

UNIT V – STUDY OF OTHER SPECIAL ELECTRICAL MACHINES
Principle of operation and characteristics of hysteresis motor – AC series motors – Linear motor – Applications.

30 PERIODS

LAB COMPONENT: 30PERIODS
Using electromagnetic software
1) Simulation of BLDC motor
2) Simulation of SR Mmotor
3) Simulation of steppe rmotor
4) Simulation of PMSM motor
5) Simulation of any other special machines

TOTAL:30+30=60PERIODS

REFERENCES:
1. JacekF.Gieras, Dr.Rong-JieWang, Professor MaartenJ.Kamper-Axial Flux Permanent Magnet Brushless Machines-Springer Netherlands 2008.
2. Bilgin, Berker Emadi, AliJiang, James Weisheng-Switched reluctance motor drives: fundamentals to applications-CRC 2019.
3. Ramu Krishnan-Permanent Magnet Synchronous and Brushless DC Motor Drives-CRCPress, Marcel Applications -CRC Press 2009
4..T.Kenjo,‘Stepping motors and their microprocessor controls’, Oxford University press, NewDelhi, 2000 Dekker 2009
5.T.J.E.Miller, ‘Brushless magnet and Reluctance motor drives’, Clar end on press,London,1989
6..R.Krishnan- Switched Reluctance Motor Drives Modeling, Simulation, Analysis, Design, and Applications -CRC Press 2017.